To the top of the document
Cruze
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Coolant System Flushing

Note: Do not use a chemical flush.

Store used coolant in the proper manner, such as in a used engine coolant holding tank.

Do not pour used coolant down a drain. Ethylene glycol antifreeze is a very toxic chemical.

Do not dispose of coolant into the sewer system or ground water. This is illegal and ecologically unsound.

Various methods and equipment can be used to flush the cooling system. If special equipment is used, such as a back flusher, follow the manufactures instruction. However, always remove the thermostat before back flushing the system.

  1. Apply the handbrake.
  2. Drain the coolant. Refer to Cooling System Draining and Filling .
  3. Fill the coolant system with clean drinkable water. Refer to Cooling System Draining and Filling .
  4. Start the engine and run at 2,000 RPM until the thermostat opens.
  5. Turn OFF the engine.
  6. Drain the coolant system. Refer to Cooling System Draining and Filling .
  7. Repeat the above procedure until the water from the coolant system is colourless.
  8. Drain the coolant system. Refer to Cooling System Draining and Filling .
  9. Add 3.8 litres (1.0 gal) of concentrated antifreeze since there will be some water in the system.
  10. Add a mixture of 50/50 antifreeze and clean drinkable water until the level stabilises at the weld seam on the surge tank. Refer to Cooling System Draining and Filling .
   


© Copyright Chevrolet. All rights reserved