To the top of the document
Cruze
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Steering Wheel Inflatable Restraint Module Coil Replacement


1998552

Callout

Component Name

Preliminary Procedures

  1. Remove the steering column upper trim cover. Refer to Steering Column Upper Trim Cover Replacement .
  2. Remove the steering column lower trim cover. Refer to Steering Column Lower Trim Cover Replacement .
  3. Remove the steering wheel. Refer to Steering Wheel Replacement .

1

Steering Wheel Inflatable Restraint Module Coil Screw Bolt (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
1.5 N·m (13 lb in)

2

Steering Wheel Inflatable Restraint Module Coil

Procedure

Disconnect any electrical connectors as needed.

Tip

    • Do not remove the centring tab from a new steering wheel inflatable restraint module coil until it has been installed or re-centring will be required.
    • If re-centring of the steering wheel inflatable restraint module coil is needed then refer to Inflatable Restraint Steering Wheel Module Coil Centring .
   


© Copyright Chevrolet. All rights reserved