- Remove 2 mode valve lever (1).
Note: The mode valve levers have to be fitted to the according mode valve gears in figured position. The ventilation dampers have to be in middle position.
- Make sure that mode valve gears of mode valve levers (1) are fitted as shown in graphic above.
Note: The mode control cam can only be fitted in one position.
- Install mode control cam (1).
Caution: Refer to Fastener Caution in the Preface section.
- Install instrument panel tie bar (2).
| • | Install 4 instrument panel tie bar bolts (3, 4) and tighten to 22 N·m (17 lb ft). |
| • | Install 2 instrument panel tie bar nuts (1) and tighten to 9 N·m (80 lb in). |
- Install instrument panel wiring harness (2) from instrument panel tie bar (1).
Connect electrical connectors.
- Install instrument panel assembly. Refer to Instrument Panel Assembly Replacement .
