DEFINITION: Brake system releases and returns to rest slowly; vehicle motion is hindered by brake system briefly after release of brake pedal.

Were you sent here from the Hydraulic Brake Symptom table?

Go to Step 2

--

1. Inspect the hydraulic brake system for the following conditions:

•	Improper operation of wheel cylinder pistons, if equipped

•	Improper operation of calliper pistons

•	Internally damaged flexible brake hoses; hindering brake release

•	Contaminated brake fluid

•	Damaged or improperly operating master cylinder

2. Adjust, repair or replace components as necessary. Refer to Hydraulic Brake System Diagnosis .

Did you find and correct a condition?

Go to Step 6

Go to Step 3

1. Inspect the brake assist system for the following conditions:

•	Binding, bent or damaged pedal pushrod, pedal, or pedal bracket

•	Damaged or improperly operating vacuum booster, if equipped

•	Restricted return hose from hydraulic booster, if equipped

•	Damaged or improperly operating hydraulic booster, if equipped

2. Adjust, repair or replace components as necessary. Refer to Brake Assist System Diagnosis .

Did you find and correct a condition?

Go to Step 6

Go to Step 4

1. Inspect the drum brake system, if equipped, for the following conditions:

•	Weak or damaged return spring or springs

•	Distorted or damaged linings

•	Out of round or damaged drum

•	Lack of lubrication on backing plate

•	Distorted or damaged backing plate

2. Adjust, repair or replace components as necessary. Refer to Drum Brake System Diagnosis .

Did you find and correct a condition?

Go to Step 6

Go to Step 5

1. Inspect the disc brake system for the following conditions:

•	Damaged or excessively worn calliper hardware and/or lining hardware

•	Distorted or damaged linings

•	Lack of lubrication or excessive corrosion on metal to metal contact surfaces

•	Bent or damaged calliper or mounting component

2. Adjust, repair or replace components as necessary. Refer to Disc Brake System Diagnosis .

Did you find and correct a condition?

Go to Step 6

--

1. Install or connect components that were removed or disconnected during diagnosis.
2. Road test the vehicle in order to confirm proper operation. Refer to Brake System Vehicle Road Test .

Is the condition still present?

Go to Step 2

System OK