Cruze

Electronic Brake Control Module Programming and Setup

The following service procedures require either a programming or a setup event performed for a complete repair.

If the electronic brake control module (EBCM) needs to be replaced, the following procedures must be performed:

1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .
2. Perform the SPS function Electronic Brake Control Module - Programming and follow the onscreen instructions.
3. Perform the SPS function Electronic Brake Control Module - Configuration & Setup and follow the onscreen instructions. On the screen Control Module - Configuration and Setup Function(s), select both ECU Configuration / Reconfiguration and ECU Setup.
4. Clear DTCs after completing the programming procedure.

If the EBCM needs to be reprogrammed, the following procedures must be performed:

1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .
2. Perform the SPS function Electronic Brake Control Module - Programming and follow the onscreen instructions.
3. Clear DTCs after completing the programming procedure.

The replacement of some components will require a setup procedure for complete repair.

If any of the following components are replaced, the corresponding procedure must be performed.

Steering Angle Sensor

Calibrate the steering angle sensor. Refer to Steering Angle Sensor Centreing .

Multi-Axis Acceleration Sensor

Calibrate the multi-axis acceleration sensor. Refer to Vehicle Yaw Sensor Learn .

Brake Pressure Modulator Valve Assembly

Calibrate the brake pressure sensor. Refer to Brake Pressure Modulator Valve Pressure Sensor Calibration .