Cruze

Drive Belt Replacement

For equivalent regional tools, refer to Special Tools .

1. Open the bonnet.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
3. Remove the right front compartment splash shield. Refer to Front Compartment Splash Shield Replacement .



4. Install EN-48488 holding wrench (2) to the drive belt tensioner (1).



5. Move the drive belt tensioner clockwise until the drive belt tensioner can be fixed with EN-955-2 locking pin (1).
6. Remove the EN-48488 holding wrench.
7. Lower the vehicle.
8. Remove the right engine mount. Refer to Engine Mount Replacement - Right Side .
9. Remove the drive belt.

1. Install the drive belt.
2. Install the right engine mount. Refer to Engine Mount Replacement - Right Side .
3. Raise the vehicle.



4. Install the EN-48488 holding wrench (2) to the drive belt tensioner (1).



5. Move the drive belt tensioner clockwise until EN-955-2 locking pin (1) can be removed.
6. Allow the tensioner to slide back slowly.
7. Remove the EN-48488 holding wrench.
8. Install the front compartment splash shield right side. Refer to Front Compartment Splash Shield Replacement .
9. Lower the vehicle.
10. Close the bonnet.