Cruze

Ignition Coil Replacement

Special Tools

EN-6009 Remover and Installer Ignition Module

For equivalent regional tools, refer to Special Tools .

1. Remove engine sight shield.



2. Disconnect ignition coil wiring harness plug (2) from ignition coil (1).



3. Remove the 2 ignition coil bolts (1).



4. Install EN-6009 remover/installer (1) to ignition coil (2).
5. Remove the ignition coil.

1. Install the ignition coil.



2. Remove EN-6009 remover (1) from ignition coil (2).

Caution: Refer to Fastener Caution in the Preface section.




3. Install the 2 ignition coil bolts (1) and tighten to 8 N·m (71 lb in).



4. Connect ignition coil wiring harness plug (2) to ignition coil (1).
5. Install engine sight shield.