Cruze

Manual Gearbox Gear Lever and Selector Lever Cable Adjustment

Special Tools

DT-527-A Adjuster

For equivalent regional tools, refer to Special Tools .

1. Shift transmission into NEUTRAL.



2. Remove mat (1).
3. Clip instrument panel lower centre compartment liner (2) out of front floor console using a suitable plastic tool (3).



4. Unlock gear shift lever and selector lever cable adjust locks (1), by pushing back the spring force loaded black sliding ring until self-locking.
5. Unlock the left cable trough the opening at the housing (arrow) using a suitable tool.



6. Slide transmission control lever boot upwards.
7. Press 2 catches (arrows).
8. Slide blue transmission control lever retainer ring (1) upwards.
9. Pull trigger (2) upwards.
10. Remove transmission control lever knob.



11. Turn transmission control lever knob (1) 180° and install to transmission control lever.
12. Push the 2 pins (2) into the 2 holes (3).
13. Remove engine control module from battery tray and lay aside.



14. Block transmission control housing (2) using DT-527-A adjuster (1).

Note: When locking the adjuster locks (1) a defined snap noise should be audible / a snap effect should be felt.

1. Lock gear lever and selector lever cable adjust locks.
2. Lock gear shift lever and selector lever cable adjust locks (1), by pushing down the two blue locking pieces WITHOUT touching/pre-loading the fixed gear shift lever.



3. Install transmission control lever knob.

Turn the transmission control lever knob back 180°.

4. Press the transmission control lever knob during installation completely down. Push trigger (2) upwards.
5. Slide blue transmission control lever retainer ring (1) downwards.
6. Remove DT-527-A adjuster from transmission control housing.
7. Check correct shifting function.
8. If necessary repeat adjusting procedure.



9. Clip instrument panel lower centre compartment liner (2) into front floor console.
10. Install mat (1).