Cruze

Manual Transmission Shift Lever and Selector Lever Cable Replacement

Special Tools

DT-6042-A Dismantling Key

For equivalent regional tools, refer to Special Tools .

1. Remove battery tray. Refer to Battery Tray Replacement .



2. Remove gear shift lever and selector lever cable (2) from transmission control housing (4) using DT-6042-A dismantling key (3).
3. Remove gear shift lever and selector lever cable from gear shift lever and selector lever cable bracket (1) by pushing back locking rings in counter driving direction.



4. Remove gear lever and selector lever cable (1) from bulkhead.
5. Remove front floor console. Refer to Front Floor Console Replacement .



6. Unlock shift lever and selector lever cable adjust locks (2).
7. Clip shift lever and selector lever cable (3) out of transmission control lever housing (1).

Note: Do not lock yet.

1. Slide shift lever and selector lever cable into shift lever and selector lever cable adjust locks (2).
2. Clip shift lever and selector lever cable (3) into transmission control lever housing (1).




Note: Install the guide with the white marking upwards to the bulkhead. Do not cross the cables.

3. Install gear lever and selector lever cable from inside the vehicle.
4. Install gear lever and selector lever cable (1) to bulkhead.
5. Check for correct fit.



6. Install gear lever and selector lever cable (2) to gear lever and selector lever cable bracket (1).
7. Install gear lever and selector lever cable to transmission control housing (3).
8. Install battery tray. Refer to Battery Tray Replacement .
9. Adjust shift lever and selector lever cable. Refer to Manual Gearbox Gear Lever and Selector Lever Cable Adjustment .