Cruze

Turbocharger Oil Return Pipe Replacement

1. Open the bonnet.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle




Note: Simplified Graphic. DO NOT remove the warm up three way catalytic converter.

3. Remove the 2 turbocharger oil return pipe bolts (1).
4. Place a drain pan below the vehicle.
5. Release the turbocharger oil return pipe connector (4) and disconnect the turbocharger oil return pipe from the engine block.
6. Remove the turbocharger oil return pipe (2) and the gasket (3).

1. Clean the sealing surfaces.



2. Install the turbocharger oil return pipe (2) in compound with a NEW gasket (3) and connect to the engine block.

Caution: Refer to Fastener Caution in the Preface section.

3. Install the 2 turbocharger oil return pipe bolts (1) and tighten to 8 N·m (71 lb in).
4. Lower the vehicle.
5. Check engine oil level.
6. Close the bonnet.