Cruze

Automatic Transmission Flex Plate Installation

Special Tools

EN-652 Flywheel Holder

For equivalent regional tools, refer to Special Tools .

1. Clean the 6 screw bores. Rework if necessary.



2. Install the automatic transmission flex plate (1).
3. Install 6 NEW automatic transmission flex plate bolts (2).



4. Install EN-652 flywheel holder (1) in order to fix the automatic transmission flex plate (2).

Caution: Refer to Fastener Caution in the Preface section.

Caution: Refer to Torque-to-Yield Fastener Caution in the Preface section.

5. Tighten the 6 automatic transmission flex plate bolts in a cross sequence to 35 N·m(26 lb ft).
6. Tighten the 6 automatic transmission flex plate bolts in a cross sequence to an additional 30°.
7. Tighten the 6 automatic transmission flex plate bolts in a cross sequence to an additional 15°.