Fuel Injection Pump Installation
Special Tools
EN-50434 Dust Cap - Fuel Rail Port
For equivalent regional tools, refer to Special Tools .
Note: Do not tilt the fuel injection pump actuator at the inlet camshaft.
- Install the fuel injection pump (1).
Caution: Refer to Fastener Caution in the Preface section.
- Install the 3 fuel injection pump retaining bolts (2) and tighten to 22 N·m (16 lb ft).
- Remove the EN-50434 dust cap .
- Install the fuel feed pipe (1).
- Install 2 fuel injection fuel feed pipe nuts to the fuel feed rail and the fuel injection pump. Tighten the fuel pipe nuts to 27 N·m (20 lb ft).
© Copyright Chevrolet. All rights reserved |