To the top of the document
Cruze
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Camshaft Position Sensor Replacement

Removal Procedure
  1. Remove the engine sight shield. Refer to Engine Sight Shield Replacement .

    2. 2512646
  2. Disconnect the camshaft position sensor wiring harness plug.
  3. Remove the camshaft position sensor bolt (3) and the camshaft position sensor (2).
  4. Remove the camshaft position sensor gasket (1).

Installation Procedure

    2512646
  1. Install the camshaft position sensor (2) with a NEW camshaft position sensor gasket (1).

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the camshaft position sensor bolt (3) and tighten to 10 N·m (89 lb in).
  3. Connect the camshaft position sensor wiring harness plug.
  4. Install the engine sight shield. Refer to Engine Sight Shield Replacement .
   


© Copyright Chevrolet. All rights reserved