To the top of the document
Cruze
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

DTC B3885 or B3886

Diagnostic Instructions
    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors

DTC B3885 02: Trailer Left Tail Lamp Circuit Short to Ground

DTC B3885 04: Trailer Left Tail Lamp Circuit Open

DTC B3886 02: Trailer Right Tail Lamp Circuit Short to Ground

DTC B3886 04: Trailer Right Tail Lamp Circuit Open

Diagnostic Fault Information

Circuit

Short to Ground

Open/High Resistance

Short to Voltage

Signal Performance

Trailer Left Tail Lamp Control

3885 02

3885 04

--

--

Trailer Right Tail Lamp Control

B3886 02

B3886 04

--

--

Circuit/System Description

The headlamp switch is supplied with ground at all times. When the headlamp switch is placed in either the park or dipped beam position, ground is applied to the tail lamp signal circuit to the body control module (BCM). The BCM sends this message to the trailer lighting converter. The trailer lighting converter then applies a voltage to the appropriate trailer tail lamp through there respective voltage supply circuits.

Conditions for Running the DTC

B3885 02, B3885 04, B3886 02 and B3886 04

The appropriate trailer tail lamp signal is active.

Conditions for Setting the DTC

B3885 02 or B3886 02

The trailer lighting converter detects a short to ground on the control circuit.

B3885 04 or B3886 04

The trailer lighting converter detects an open control circuit.

Conditions for Clearing the DTC

The condition for setting the DTC is not longer present.

Action Taken When the DTC Sets

The appropriate trailer tail lamp is inoperative.

Reference Information

Schematic Reference

Exterior Lamps Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Exterior Lighting Systems Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

Ignition ON, perform the appropriate Trailer Tail Lamp test. The appropriate trailer tail lamp should be ON/OFF.

Circuit/System Testing
  1. Ignition OFF, test for less than 5 Ω between the X88 Trailer Connector terminal 3, 11, 13 and ground.
    2. ⇒If greater than the specified value, test the appropriate ground circuit for an open/high resistance.
  2. Connect a test lamp between the appropriate X88 Trailer Connector terminal listed below and ground.
    3. • X88 Trailer Connector terminal 5
    • X88 Trailer Connector terminal 7
  3. Command the appropriate Trailer Tail Lamp Active/Inactive test with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
    4. ⇒If the test lamp is always ON, test the signal circuit for a short to voltage. If the circuit tests normal, replace the K68 Trailer Lighting Control Module.
    ⇒If the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance. If the circuits test normal, replace the K68 Trailer Lighting Control Module.
  4. If all the circuits test normal, test the appropriate tail lamp circuit at the trailer.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for trailer lighting control module replacement, setup and programming

   


© Copyright Chevrolet. All rights reserved