Orlando

Fuel Injector Replacement

Special Tools

For equivalent regional tools, refer to Special Tools .

1. Remove the engine sight shield. Refer to Engine Sight Shield Replacement .
2. Remove the 4 fuel injection fuel feed pipes - fuel rail to fuel injector. Refer to Fuel Injection Fuel Feed Pipe Replacement - Fuel Rail to Fuel Injector .
3. Remove the fuel injection fuel feed pipe - fuel pump to fuel rail. Refer to Fuel Injection Fuel Feed Pipe Replacement - Fuel Injection Pump to Fuel Rail .



4. Remove and DISCARD the 4 fuel injector bracket retaining bolts (2).
5. Remove the 4 fuel injector brackets (3).
6. Remove the 4 fuel injectors (1), using the EN-50428 remover . Remove the 4 inner camshaft cover retaining bolts to use remover.
7. Close the 4 fuel injector nozzles with the EN-48559 protective caps .

Note: Use both sides of EN-47632 cleaning tool, one for loosening the dirt and the other to remove the dirt.

1. Clean the sealing surfaces, use the EN-47632 cleaning tool .

Caution: Refer to Fastener Caution in the Preface section.




2. Install the 4 camshaft cover retaining bolts. Tighten the bolts to 10 N·m (89 lb in).
3. Remove the 4 EN-48559 protective caps .
4. Install the 4 fuel injectors (1).
5. Install the 4 fuel injector brackets (3).

Caution: Refer to Torque-to-Yield Fastener Caution in the Preface section.

6. Install the 4 NEW fuel injector bracket retaining bolts (2). Tighten the bolts to 14 N·m + 110° (10 lb ft + 110°).
7. Install the 4 fuel injection fuel feed pipes - fuel rail to fuel injector. Refer to Fuel Injection Fuel Feed Pipe Replacement - Fuel Rail to Fuel Injector .
8. Install the fuel injection fuel feed pipe - fuel pump to fuel rail. Refer to Fuel Injection Fuel Feed Pipe Replacement - Fuel Injection Pump to Fuel Rail .
9. Install the engine sight shield. Refer to Engine Sight Shield Replacement .