To the top of the document
Spark
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Engine Flywheel Installation

Special Tools

    • EN-652 Fixing Tool
    • EN-470-B Torque Angle Sensor

For equivalent regional tools, refer to Special Tools

  1. Install the EN-652 fixing tool in order to fix the engine flywheel.
  2. Recut the 8 threads in the crankshaft.

  3. 2189550
  4. Install the engine flywheel (1).
  5. Caution: Refer to Fastener Caution in the Preface section.

    Caution: Refer to Torque-to-Yield Fastener Caution in the Preface section.

    Note: Service may offer bolts that are not microencapsulated. If this is the case apply thread lock agent to the bolt. If fastener is micro-encapsulated, install a NEW engine flywheel bolt. DO NOT reuse the old bolt.

  6. Install the 8 NEW engine flywheel bolts (2) and tighten in the following order:
  7. 4.1. Tighten the bolts to 20 N·m(15 lb ft).
    4.2. Tighten to additional 90 °, use the EN-470-B torque angle sensor .
  8. Remove the EN-652 fixing tool.
   


© Copyright Chevrolet. All rights reserved