To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

DTC B1001

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC B1001 45: Option Configuration Error Variant Not Programmed

Circuit/System Description

The internal fault detection is handled inside the control module. No external circuits are involved.

Conditions for Running the DTC

The only requirements are voltage and ground.

Conditions for Setting the DTC

The module has detected that the restraints ID number is not programmed.

Conditions for Clearing the DTC

    • A current DTC clears when the malfunction is no longer present.
    • A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.

Circuit/System Verification

  1. Program the restraints ID into the body control module (BCM).
  2. Retrieve DTCs from the BCM. DTC B1001 45 should change to a history DTC.
  3. If the DTC remains current, replace the BCM.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the repair.

Control Module References for BCM replacement, setup, and programming

   


© Copyright Chevrolet. All rights reserved