To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Manifold Absolute Pressure Sensor Replacement - LE5 or LE9

Removal Procedure

  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement : LE5 or LE9

  2. 1571757
  3. Remove the evaporative emission (EVAP) canister purge tube from the intake manifold. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Move the EVAP canister purge tube out of the way.
  5. Disconnect and move the fuel injector wiring harness out of the way.

  6. 1581050
  7. Disconnect the engine harness electrical connector from the manifold absolute pressure (MAP) sensor.
  8. Remove the MAP sensor and seal.

Installation Procedure


    1581050
  1. Lubricate the NEW MAP sensor seal with clean engine oil.
  2. Install the MAP sensor into the intake manifold.
  3. Connect the engine harness electrical connector to the MAP sensor.
  4. Position and connect the fuel injector wiring harness.

  5. 1571757
  6. Position the EVAP canister purge tube to the intake manifold.
  7. Connect the EVAP canister purge tube to the intake manifold. Refer to Plastic Collar Quick Connect Fitting Service .
  8. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement : LE5 or LE9
   


© Copyright Chevrolet. All rights reserved