To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

DTC U2101

Diagnostic Instructions

    •  Perform the Diagnostic System Check - Vehicle
    •  Review Strategy Based Diagnosis
    •  Diagnostic Procedure Instructions

DTC Descriptor

DTC U2101 00: Maximum List of Control Modules Not Programmed

DTC U2101 45: Maximum List of Control Modules Not Programmed Variant Not Programmed

Circuit/System Description

Some control modules must be programmed with software that specifically identifies the correct type and quantity of control modules on the serial data bus based on RPO configuration. If a control module was not properly configured after installation, the appropriate U Code may be set for that control module. No external circuit diagnosis is involved.

Conditions for Running the DTC

    • Voltage supplied to the control module is in the normal operating voltage range.
    • The vehicle power mode requires serial data communication to occur.

Conditions for Setting the DTC

    • The control module is not configured properly.
    • Control unit recognises a programming error.
    • CAN-Bus configuration is invalid

Conditions for Clearing the DTC

    • A current DTC clears when the malfunction is no longer present.
    • A history DTC clears when the control module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.

Reference Information

Schematic Reference

Data Communication Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Data Link Communications Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Scan Tool References

Control Module References

Circuit/System Verification

  1. Verify the appropriate DTC is not set.
  2. If the DTC is set along with other codes, diagnose all other codes first. If no other codes are set, program the control module specified by the DTC descriptor.
  3. With a scan tool, clear the DTCs.
  4. Vehicle OFF, remove the scan tool, open and close the drivers door.
  5. Wait 60 seconds, then verify the DTC is not set.
  6. If the DTC is set, replace the appropriate control module.

Repair Instructions

Perform the Diagnostic Repair Verification

Control Module References

   


© Copyright Chevrolet. All rights reserved