To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Transfer Case Fluid Replacement

Removal Procedure


    1829851
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the drain plug (1).
  3. Remove the fill plug (2)

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.


    1829851
  1. Install the drain plug (1) and tighten to 39 N·m (29 lb ft).
  2. Fill the transfer case with synthetic hypoid 75W-90 to the bottom of the fill plug hole, when the vehicle is on a level surface.
  3. Install the fill plug (2) and tighten to 39 N·m (29 lb ft).
  4. Lower the vehicle.
   


© Copyright Chevrolet. All rights reserved