Captiva

Water Pump Installation

Special Tools

EN 46104 Water Pump Pulley Holding Tool

For equivalent regional tools, refer to Special Tools .

1. Ensure that the engine front cover and water pump are clear of old gasket material.
2. Ensure that the water pump mounting bolt holes in the front cover are completely clean and dry.
3. Place a new water pump gasket on the water pump.
4. Place the water pump in position on the front cover.
5. Install the water pump bolts finger tight.

Caution: Refer to Fastener Caution in the Preface section.




6. Tighten the water pump bolts in sequence to 12 N·m (106 lb in).
7. Tighten the water pump bolts a second pass in sequence to 12 N·m (106 lb in).



8. Install the water pump pulley.
9. Loosely install the water pump pulley bolts.



10. Install the EN 46104 tool (1) onto the water pump pulley and tighten the water pump pulley bolts to 10 N·m (89 lb in)

.