To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Engine Flywheel Installation

Special Tools

    • EN 45059 Angle Meter
    • EN 46106 Engine Flywheel Holding Tool

For equivalent regional tools, refer to Special Tools

  1. Place the engine flywheel in position on the crankshaft.
  2. Install 2 NEW bolts in location at the top and bottom of the engine flywheel bolt pattern allowing the engine flywheel to hang in position.

  3. 945978
  4. Install the EN 46106 tool .
  5. Caution: Refer to Fastener Caution in the Preface section.


    1871066
  6. Install the remaining NEW engine flywheel bolts.
  7. 4.1. Tighten the NEW engine flywheel bolts to 30 N·m (22 lb ft).
    4.2. Tighten the NEW engine flywheel bolts an additional 45 degrees using the EN 45059 meter .

    945978
  8. Remove the EN 46106 tool.
   


© Copyright Chevrolet. All rights reserved