To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Knock Sensor Replacement - LD9

Removal Procedure

    Warning: Refer to Battery Disconnect Warning in the Preface section.


    1760894
  1. Disconnect the negative battery cable.
  2. Raise and suitably support the vehicle.
  3. Disconnect the knock sensor connector.

  4. 1760895
  5. Remove the knock sensor retaining bolt.
  6. Remove the knock sensor.

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.


    1760895
  1. Install the knock sensor with the bolt.
  2. Tighten
    Tighten the knock sensor retaining bolt to 20 N·m (15 lb ft).


    1760894
  3. Connect the knock sensor connector.
  4. Lower the vehicle.
  5. Connect the negative battery cable.
   


© Copyright Chevrolet. All rights reserved