To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Rear Wheel Drive Module Clutch Housing Replacement


1814482

Callout

Component Name

Preliminary Procedures

  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the propeller shaft from the differential clutch drum assembly. Refer to Propeller Shaft Replacement .

1

Electrical Clutch Control Connector

2

Retaining Clip (Qty: 2)

3

Differential Clutch Drum Bolt (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Tip
Relocate the rear portion of the propeller shaft to the side and support it with mechanics wire or equivalent.

Tighten
29 N·m (21 lb ft)

4

Differential Clutch Drum

Procedure

Rear differential clutch control module recalibration, refer to Control Module References .

Tip
The pinion flange, dust cover and pinion nut are serviced with the differential clutch drum assembly.

5

Differential Clutch Drum Gasket

Tip
Apply a small amount of grease to the gasket to hold it in place.

   


© Copyright Chevrolet. All rights reserved