To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Evaporative Emission Canister Replacement

Removal Procedure


    1371134

    Note: The EVAP emission canister is located under the centre of the vehicle. It has 3 EVAP line connections:

       • The EVAP fresh air
       • The EVAP vent
       • The EVAP purge

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Caution: Clean all fuel pipe connections and surrounding areas before disconnecting the fuel pipes to avoid contamination of the fuel system.

  3. Disconnect the EVAP canister fresh air hose/pipe from the fuel tank fresh air hose/pipe (2). Refer to Plastic Collar Quick Connect Fitting Service .
  4. Disconnect the EVAP canister vent hose/pipe from the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .

  5. 1371133
  6. Disconnect the EVAP canister purge hose/pipe (1) from the EVAP canister.
  7. Remove the EVAP canister-to-underbody nuts (3).
  8. Lower the EVAP canister.

  9. 1371134
  10. Disconnect the EVAP vent solenoid electrical connector (1).
  11. Remove the EVAP canister (4) from the vehicle.

Installation Procedure


    1371134
  1. Connect the EVAP vent solenoid electrical connector (1).
  2. Install the EVAP canister (4) to the underbody of the vehicle.
  3. Caution: Refer to Fastener Caution in the Preface section.


    1371133
  4. Install the EVAP canister-to-underbody nuts (3).
  5. Tighten
    Tighten the nuts to 9 N·m (80 lb in).

  6. Connect the EVAP canister purge hose/pipe (1) to the EVAP canister.

  7. 1371134
  8. Connect the EVAP canister vent hose/pipe (3) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  9. Connect the EVAP canister fresh air hose/pipe to the fuel tank fresh air hose/pipe (2). Refer to Plastic Collar Quick Connect Fitting Service .
  10. Lower the vehicle.
   


© Copyright Chevrolet. All rights reserved