Captiva

Fuel Pump Flow Control Module Replacement

1. Open the rear compartment floor stowage compartment cover.
2. Remove the spare tyre spacer (1).
3. Remove the rear compartment floor stowage compartment. Refer to Rear Compartment Floor Stowage Compartment Replacement : Long Body with 3rd Row Seat  → Long Body  → Short Body .



4. Disconnect the body wiring harness electrical connector (1) from the fuel pump flow control module.



5. Remove the fuel pump flow control module bolts (1).
6. Slide the fuel pump flow control module towards the driver side of the vehicle.
7. Remove the fuel pump flow control module (2) from the vehicle.

1. Install the fuel pump flow control module (2) to the vehicle.
2. Slide the fuel pump flow control module towards the passenger side of the vehicle.

Caution: Refer to Fastener Caution in the Preface section.

3. Install the fuel pump flow control module bolts (1).

Tighten
Tighten the bolts to 10 N·m (89 lb in).




4. Connect the body wiring harness electrical connector (1) to the fuel pump flow control module.



5. Install the rear compartment floor stowage compartment. Refer to Rear Compartment Floor Stowage Compartment Replacement : Long Body with 3rd Row Seat  → Long Body  → Short Body .
6. Install the spare tyre spacer (1).
7. Close the rear compartment floor stowage compartment cover.
8. Program the fuel pump flow control module. Refer to Control Module References .