To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Knock Sensor Replacement - LE5, LE9 Or LAF

Removal Procedure

  1. Hoist and raise the vehicle. Refer to Lifting and Jacking the Vehicle .

  2. 1809558
  3. Disconnect the engine wiring harness electrical connector (3) from the knock sensor electrical connector (4).
  4. Remove the knock sensor electrical connector (4) from the oil level indicator tube bracket.

  5. 1578476
  6. Remove the knock sensor bolt .
  7. Remove the knock sensor.

Installation Procedure


    1578476
  1. Install the knock sensor .
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the knock sensor bolt.
  4. Tighten
    Tighten the bolt to 25 N·m (18 lb ft).


    1809558

    Note: Rotate the knock sensor electrical connector 90 degrees from vertical before securing the fastener.

  5. Install the knock sensor electrical connector (4) to the oil level indicator tube bracket.
  6. Connect the engine wiring harness electrical connector (3) to the knock sensor electrical connector (4).
   


© Copyright Chevrolet. All rights reserved