Captiva

Ignition Coil Replacement - Bank 1

1. Remove the intake manifold. Refer to Inlet Manifold Replacement .



2. Disconnect the engine wiring harness electrical connector(s) (1) from the ignition coil(s) (4).



3. Remove the ignition coil bolt(s).
4. Remove the ignition coil(s).

1. Install the ignition coil(s).

Caution: Refer to Fastener Caution in the Preface section.

2. Install the ignition coil bolt(s).

Tighten
Tighten the bolt(s) to 10 N·m (89 lb in).




3. Connect the engine wiring harness electrical connector(s) (1) to the ignition coil(s) (4).
4. Install the inlet manifold. Refer to Inlet Manifold Replacement .