Captiva

Ignition Coil Replacement - Bank 2

1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
2. Disconnect the engine wiring harness electrical connector(s) (5) from the ignition coil(s) (4).



3. Remove the ignition coil bolt(s).
4. Remove the ignition coil(s).

1. Install the ignition coil(s).

Caution: Refer to Fastener Caution in the Preface section.

2. Install the ignition coil bolt(s).

Tighten
Tighten the bolt(s) to 10 N·m (89 lb in).




3. Connect the engine wiring harness electrical connector(s) (5) to the ignition coil(s) (4).
4. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .