Captiva

Engine Oil Pressure Switch Replacement - LE5, LE9 or LAF

1. Remove the starter. Refer to Starter Replacement : LNQ  → LF1  → LE5 .
2. Disconnect the engine wiring harness electrical connector (2) from the oil pressure switch.



3. Remove the engine oil pressure switch .

Caution: Refer to Fastener Caution in the Preface section.




1. Install the engine oil pressure switch. Tighten the switch to 22 N·m (16 lb ft).



2. Connect the engine wiring harness electrical connector (2) to the oil pressure switch.
3. Install the starter. Refer to Starter Replacement : LNQ  → LF1  → LE5 .