Captiva
Starter Replacement - LNQ
Removal Procedure
Disconnect the battery negative cable. Refer to
Battery Negative Cable Disconnection and Connection
.
Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
Remove the engine shield. Refer to
Engine Shield Replacement
.
Remove the underbody brace. Refer to
Underbody Brace Replacement
.
If equipped with AWD, remove the transfer case. Refer to
Transfer Case Assembly Replacement
.
Remove the rear transmission mount. Refer to
Transmission Mount Bracket Replacement - Rear
:
FWD
→
AWD
.
Disconnect the engine harness connector (1) from the starter.
Remove the starter nut (2), along with the alternator jumper cable (3) and the battery positive cable (4).
Remove the gearbox bolt (1) and the starter mounting bolts (2).
Remove the starter (3) from the vehicle.
Installation Procedure
Position the starter (3) to the flywheel and hand tighten starter mounting bolts (2).
Caution:
Refer to
Fastener Caution
in the Preface section.
Install the gearbox bolt (1) and tighten to
58 N·m (43 lb ft)
.
Tighten the starter mounting bolts (2) to
58 N·m (43 lb ft)
.
Install the battery positive cable (4) and the alternator jumper cable (3) to the starter post with the nut (2). Tighten to
15 N·m (11 lb ft)
.
Install the engine harness connector (1) to the starter solenoid.
Install the rear gearbox mount. Refer to
Transmission Mount Bracket Replacement - Rear
:
FWD
→
AWD
.
If equipped with AWD, install the transfer case. Refer to
Transfer Case Assembly Replacement
.
Install the underbody brace. Refer to
Underbody Brace Replacement
.
Install the engine shield. Refer to
Engine Shield Replacement
.
Lower the vehicle.
Connect the battery negative cable. Refer to
Battery Negative Cable Disconnection and Connection
.
© Copyright Chevrolet. All rights reserved