To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Camshaft Cover Assemble

Special Tools

    • DT 5590 Bearing and Seal Driver
    • J-25254-A Oil Seal Installer

For equivalent regional tools, refer to Special Tools .

Left Camshaft Cover

    1992540
  1. Install the NEW left spark plug shield tube seals using the DT 5590 driver (1) and J-25254-A installer (2).

    2. 1992532
  2. Install the NEW left camshaft cover gasket.

    3. 1992531
  3. Install the oil fill cap.

    4. Caution: Refer to Fastener Caution in the Preface section.


    1992528
  4. Install the fuel injector sight shield cover ballstud and tighten to 10 N·m (89 lb in).

    5. 1992526

    Note: The camshaft cover bolt grommet must be installed into the camshaft cover bolt hole before installing the camshaft cover bolt.

  5. Install the NEW left camshaft cover bolt grommets.

Right Camshaft Cover

    1836411
  1. Install the NEW right spark plug shield tube coil seals using the DT 5590 driver (1) and J-25254-A installer (2).

    2. 1833744
  2. Install the NEW right camshaft cover gasket.

    3. 1836419

    Note: The camshaft cover bolt grommet must be installed into the camshaft cover bolt hole before installing the camshaft cover bolt.

  3. Install the NEW right camshaft cover bolt grommets.
   


© Copyright Chevrolet. All rights reserved