Heater and Air Conditioning Control Replacement - Long Body
Removal Procedure
Warning: Refer to Battery Disconnect Warning in the Preface section.
Note: The left-hand drive is shown. The right-hand drive is similar.
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
- Remove the instrument panel accessory bezel. Refer to
Instrument Panel Accessory Bezel Replacement : Long Body → Short Body .
- Remove the control assembly retaining screws.
- Pull out the unit to gain access to the rear.
- Disconnect the electrical connectors.
- Remove the air inlet tube.
- Remove the automatic temperature control assembly.
Installation Procedure
- Connect the air inlet tube.
- Connect the electrical connectors.
Caution: Refer to Fastener Caution in the Preface section.
- Position the automatic temperature control assembly and install the retaining screws; tighten to 2.5 N·m (22 lb in).
- Install the instrument panel accessory bezel. Refer to
Instrument Panel Accessory Bezel Replacement : Long Body → Short Body .
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
© Copyright Chevrolet. All rights reserved |