To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Blower Motor Control Module Replacement

Removal Procedure

    Warning: Refer to Battery Disconnect Warning in the Preface section.


    1786031

    Note: The left-hand drive is shown. The right-hand drive is similar.

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the instrument panel storage compartment. Refer to Instrument Panel Compartment Replacement : Long Body  → Short Body .
  3. Disconnect the electrical connector at the resistor.
  4. Remove the screws from the resistor.
  5. Remove the resistor from the A/C module by gently pulling the resistor downward.

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.


    1786031
  1. Install the new resistor into the heater/air distributor case assembly with the screws and tighten to 6 N·m (53 lb in).
  2. Connect the electrical connector at the resistor.
  3. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  4. Confirm the correct performance of the blower.
  5. Install the instrument panel storage compartment. Refer to Instrument Panel Compartment Replacement : Long Body  → Short Body .
   


© Copyright Chevrolet. All rights reserved