Note: Correct adjustment cannot be achieved if the sunroof window is closed from vent position.
- Cycle the sunroof window from full open to closed position.
Note: Do Not remove or lower headliner to access sunroof window screws.
- Loosen the adjusting screws on the window.
- Adjust the corners of the front window panel using the following guidelines:
| • | Adjust the front of the sunroof window to 0.0 mm - 1.0 mm (0.0 in - 0.04 in ) below the top surface of the roof panel. |
| • | Adjust the rear centre line of the sunroof window to 2 mm to 3 mm (0.08 in to 0.12 in ) below the top surface of the roof panel. |
Caution: Refer to Fastener Caution in the Preface section.
- Tighten the sunroof window adjustment screws to 5 N·m (44 lb in).
- Cycle sunroof window through all positions.
- Inspect the sunroof window adjustment. Adjust if necessary.
