Preliminary Procedures

1. Remove either the LF or RF wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
2. Remove the inner front wheel opening moulding nut.
3. Release the retainers from the wheelhouse.
4. Release the front wheel opening moulding from the front edge of the lower rocker panel moulding.
5. Remove the front wheel opening moulding from the vehicle.

1

Front Wing Wheel Opening Moulding Nut

Caution: Refer to Fastener Caution in the Preface section.

Tip
Loosen the rear bolt at the rear of the front bumper fascia securing the wing flange to the front bumper fascia.

Tighten
4.0 N·m (35 lb in)

2

Front Wing Wheel Opening Moulding Retainer (Qty: 6)

Tip
Replace any broken retainers upon re-assembly.

3

Front Wing Wheel Opening Moulding Assembly