Captiva

Camshaft Cover Installation - Right Side

Special Tools

EN-46101 Spark Plug Tube Seal Guide

For equivalent regional tools, refer to Special Tools .

1. Install the EN-46101 guide onto the spark plug tubes of the right cylinder head.



2. Install the NEW camshaft cover bolt grommets prior to installing the camshaft cover bolts.
3. Wipe the camshaft cover sealing surface on the right cylinder head with a clean, lint-free cloth.



4. Place a bead 8 mm (0.3150 in) in diameter by 4 mm (0.1575 in) in height of RTV sealant on the engine front cover split lines (1). Refer to Adhesives, Fluids, Lubricants, and Sealers for recommended sealant.



5. Place the right camshaft cover into position on the right cylinder head.



6. Loosely install the right camshaft cover bolts.

Caution: Refer to Fastener Caution in the Preface section.




7. Tighten the right camshaft cover bolts in the sequence shown.

7.1.	Tighten the right camshaft cover bolts to 10 N·m (89 lb in).

7.2.	Tighten the right camshaft cover bolts a second pass to 10 N·m (89 lb in).




8. Remove the EN-46101 guide from the spark plug tubes of the right cylinder head.



9. Install the NEW spark plugs into the right cylinder head and tighten to 18 N·m (13 lb ft).



10. Install the ignition coils.



11. Install the ignition coil bolts and tighten to 10 N·m (89 lb in).