To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Engine Oil Pressure Sensor and/or Switch Replacement

Removal Procedure


    1832048
  1. Turn the ignition OFF.
  2. Disconnect the oil pressure sensor electrical connector.
  3. Remove the oil pressure sensor (1).

Installation Procedure

    Caution: Refer to Component Fastener Tightening Caution in the Preface section.


    1832048
  1. Install the oil pressure sensor (1) and tighten to 20 N·m (15 lb ft).
  2. Connect the oil pressure sensor electrical connector.
   


© Copyright Chevrolet. All rights reserved