To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Servo Unit Vacuum Sensor Replacement - LHD 3.0L

Removal Procedure
  1. With the engine OFF, apply and release the brake pedal several times until the brake pedal becomes firm to deplete the power vacuum brake booster vacuum reserve.
  2. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .

    3. 2429160
  3. Remove the power brake booster vacuum sensor (1) from the power vacuum brake booster.

    4. 2429162
  4. Release the spring clamp and remove the power brake booster vacuum sensor (1) from the power brake booster vacuum hose.

Installation Procedure

    2429162

    Note: A small amount of methylated spirit may be used to ease assembly. Do not use soap.

  1. Install the power brake booster vacuum sensor (1) to the power brake booster vacuum hose and secure the spring clamp.

    2. 2429160

    Note: A small amount of methylated spirit may be used to ease assembly. Do not use soap.

  2. Install the power brake booster vacuum sensor (1) to the power vacuum brake booster.
  3. Install the inlet manifold cover. Refer to Intake Manifold Cover Replacement .
   


© Copyright Chevrolet. All rights reserved