To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Engine Support Fixture

Special Tools

    • EN-28467-B Universal Engine Support Fixture
    • EN-28467-7A Bolt Hook
    • EN-28467-13 Engine Support Fixture Adapters
    • EN-28467-34 Lift Hook Wing Nut and Washer
    • EN-36462-A Engine Support Adapter Leg Set
    • EN-42451-1 Engine Support Adapter
    • GM P/N 11519137 4 Studs or equivalent

For equivalent regional tools, refer to Special Tools .

Installation Procedure


    1853722
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Remove the air inlet screen. Refer to Air Inlet Grille Panel Replacement : Short Body .
  3. Install two M8 x 1.25 double-ended studs to each strut tower with 30 mm engagement to the strut tower and 16 mm engagement to the EN-28467-13 adapters .
  4. Install three EN-28467-13 adapters (1) and two J 28467-5 strut tower adapters (2) to the top of the left and right strut tower.
  5. Install a 127 cm (50 in) engine support fixture cross bar EN-28467-B support fixture (3) transversely across the vehicle between both J 28467-5 strut tower adapters (2).
  6. Insert safety pins J-28467-10 (4) through the J 28467-5 strut tower adapters (2) and the cross bar (3) to prevent movement.

  7. 2289251
  8. Install the EN-42451-1 engine support bracket to the engine.

  9. 2289248
  10. Install the EN-42451-1 engine support bracket to the engine.

  11. 1853723
  12. Position two 58 cm (23 in) engine support fixture cross bars (1) longitudinally with two EN-36462-A leg assemblies (2).
  13. Install two J 28467-1A clamps (3) to secure the longitudinal mounted cross bar to the transverse mounted cross bar.

  14. 682139
  15. Assemble the l EN-28467-34 wing nut and the lift hook bracket J-28467-6A to the EN-28467-7A lift hook .

  16. 682301
  17. Install the lift hook and bracket assembly (1) to the longitudinal mounted cross bar (2).

  18. 2289251
  19. Position the EN-28467-7A lift hook to the rear engine lift bracket EN-42451-1 engine support bracket (2).

  20. 682139
  21. Assemble the EN-28467-34 wing nut and the lift hook bracket J-28467-6A to the EN-28467-7A lift hook .

  22. 682301
  23. Install the lift hook and bracket assembly (1) to the longitudinal mounted cross bar (2).

  24. 2289248
  25. Position the EN-28467-7A bolt hook (1) to the front engine lift bracket EN-42451-1 engine support bracket (2).

  26. 1853754
  27. Evenly tighten both EN-28467-34 wing nuts (1) until the engine weight is supported by the engine support fixture and no longer carried by the engine mounts.
   


© Copyright Chevrolet. All rights reserved