To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Power Brake Booster Vacuum Check Valve and Hose Replacement — RHD 2.0L, 2.2L Diesel

Removal Procedure

  1. With the engine OFF, apply and release the brake pedal several times until the brake pedal becomes firm to deplete the power vacuum brake booster vacuum reserve.
  2. Remove the engine sight shield. Refer to Engine Sight Shield Replacement .
  3. Disconnect the power brake booster vacuum sensor electrical connector, if equipped.

  4. 2443997
  5. Remove the power brake booster vacuum check valve (1) and hose from the vacuum power brake booster.

  6. 2429248
  7. Release the spring clamp and remove the power brake booster vacuum hose (1) from the vacuum pump port.
  8. Release the power brake booster vacuum hose from the routing clips.
  9. Remove the power brake booster vacuum hose and check valve assembly.

Installation Procedure


    2429248

    Note: A small amount of methylated spirit may be used to ease assembly. Do not use soap.

  1. Install the power brake booster vacuum hose (1) to the vacuum pump port and secure the spring clamp.

  2. 2443997

    Note: A small amount of methylated spirit may be used to ease assembly. Do not use soap.

  3. Install the power brake booster vacuum check valve (1) and hose to the vacuum power brake booster.
  4. Install the power brake booster vacuum hose to the routing clips.
  5. Connect the power brake booster vacuum sensor electrical connector, if equipped.
  6. Install the engine sight shield. Refer to Engine Sight Shield Replacement .
   


© Copyright Chevrolet. All rights reserved