To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Electronic Brake Control Module Programming and Setup

EBCM Replacement

If the electronic brake control module (EBCM) is replaced, the following procedures must be performed:

  1. EBCM Reprogramming, refer to Service Programming System (SPS) .
  2. The steering angle sensor will require a setup procedure for complete repair. Refer to Steering Angle Sensor Centreing .
  3. Relearn the yaw rate calibration using the scan tool, perform the Yaw/Lateral Sensor Relearn. Refer to Vehicle Yaw Sensor Learn .

EBCM Reprogramming

If the electronic brake control module (EBCM) needs to be reprogrammed, the following procedures must be performed:

  1. EBCM Reprogramming, refer to Service Programming System (SPS) .
  2. The steering angle sensor will require a setup procedure for complete repair. Refer to Steering Angle Sensor Centreing .
  3. Relearn the yaw rate calibration using the scan tool, perform the Yaw/Lateral Sensor Relearn. Refer to Vehicle Yaw Sensor Learn .

Setup for Component Replacement

The replacement of some components will require a setup procedure for complete repair.

If any of the following components are replaced, the corresponding procedure must be performed.

Steering Angle Sensor

Calibrate the steering angle sensor. Refer to Steering Angle Sensor Centreing .

Multi-axis Accelerometer Sensor or Yaw/Lateral Accelerometer Sensor

Relearn the yaw rate calibration using the scan tool, perform the Yaw/Lateral Sensor Relearn. Refer to Vehicle Yaw Sensor Learn .

   


© Copyright Chevrolet. All rights reserved