To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

DTC B1016

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using the diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC B1016 00: Vehicle Identification Number (VIN) Information Not Programmed

Circuit Description

After battery power has been restored following a loss of power, the theft deterrent module (TDM) will perform a check on the stored vehicle identification number (VIN). If the VIN is CORRECT, the TDM will run the VIN Timer for a programmable length of time, typically 10 minutes. The TDM will send a message via the serial data circuit to the instrument panel cluster (IPC) to illuminate the SECURITY indicator. After the VIN Timer has timed out, the security indicator will turn OFF. If the VIN is INCORRECT, the TDM will send the fuel disable password to the engine control module (ECM), via the serial data circuit. The immobiliser system considers this to be an indication of tampering and will not allow the vehicle to start. The TDM will send a message via the serial data circuit to the IPC to flash the SECURITY indicator.

Conditions for Running the DTC

Ignition ON

Conditions for Setting the DTC

    • The VIN check flag of the TDM is true.
    • The TDM has determined that the battery has been reconnected after a battery disconnect.

Action Taken When the DTC Sets

    • The vehicle will not start.
    • The TDM sends the fuel disable message via the serial data circuit to the ECM.
    • The TDM sends a message to the IPC to illuminate the SECURITY indicator.

Conditions for Clearing the DTC

The TDM clears the current DTC when the correct VIN information is present.

Reference Information

Schematic Reference

Immobiliser Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Immobiliser Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

With a scan tool, verify DTC B1016 is not set.

If DTC is set, program the TDM. If DTC resets, replace the TDM.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the repair.

Control Module References for TDM replacement, set-up and programming

   


© Copyright Chevrolet. All rights reserved