To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

DTC B1008

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC B1008 00: Calibration Data Not Programmed

Circuit/System Description

When replacing a remote control door lock receiver (RCDLR), the service replacement part is shipped with no installed software. Before the new RCDLR is operational, it is necessary to download a software calibration using the SPS terminal. Failure to download this software calibration will result in the setting of DTC B1008.

Conditions for Running the DTC

This DTC runs continuously

Conditions for Setting the DTC

The RCDLR has no calibration loaded.

Action Taken When the DTC Sets

All functions handled by the RCDLR are inoperative

Conditions for Clearing the DTC

A current DTC will clear when software calibrations are installed.

Reference Information

Schematic Reference

Remote Function Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Keyless Entry System Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

Perform the RCDLR Programming and Setup procedure. Refer to Remote Control Door Lock Receiver Programming and Setup .

If the DTC resets, replace the RCDLR.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for RCDLR replacement, setup, and programming

   


© Copyright Chevrolet. All rights reserved