Warning: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling. Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs.

Warning: Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs.

Preliminary Procedures

1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
2. Remove the front side door trim panel. Refer to Front Side Door Trim Panel Replacement : Long Body  → Short Body .

1

Inflatable Restraint Side Impact Sensor Assembly

Caution: Refer to Fastener Caution in the Preface section.

Procedure

1. Loosen the fastener and slide the sensor out of the keyhole slot.
2. The bolt is integral to the sensor assembly, DO NOT remove separately.
3. Disconnect the electrical connector.

Tip
The sensor is located on the inside of the front door inner panel.

Tighten
7.5 N·m (66 lb in)