Service Information

Captiva

DTC P06B8 - LNP or LNQ

Diagnostic Instructions

•	Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

•	Review Strategy Based Diagnosis for an overview of the diagnostic approach.

•	Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P06B8 00: Control Module Random Access Memory Performance

Circuit/System Description

These DTCs apply to internal microprocessor integrity conditions within the engine control module (ECM). This diagnostic also addresses if the ECM is not programmed.

Conditions for Running the DTC

•	The ignition is ON.

•	These DTCs run continuously once the above condition is met.

Conditions for Setting the DTC

The ECM detects an internal condition for greater than 1 s.

Action Taken When the DTC Sets

DTC P06B8 00 is a Type A DTC.

Conditions for Clearing the DTC

DTC P06B8 00 is a Type A DTC.

Reference Information

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Circuit/System Testing

Program the ECM. If DTC P068B 00 sets after programming, perform the following steps:

•	Ensure that all connections are secure.

•	Ensure the programming equipment is operating correctly.

•	Ensure the correct software and the correct calibration is used.

•	Attempt to program the K20 Engine Control Module.

⇒	If DTC P06B8 00 sets, replace the K20 Engine Control Module.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for ECM replacement, setup, and programming