To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Balance Shaft Installation - LE5 or LE9

Special Tools

EN-43650 Balance Shaft Bush Remover/Installer

For equivalent regional tools, refer to Special Tools : LE5 or LE9 .


    2146378
  1. Install the balance shaft bush using the EN-43650 installer (1).

    2. 2146379
  2. Seat the balance shaft bush into the bore using the EN-43650 installer (1) and a wrench.
  3. When the EN-43650 installer is fully seated in the engine block, remove it with a wrench.

    4. 2146297

    Note: If the balance shafts are not properly timed to the engine, the engine may vibrate or make noise.

  4. Place the number one piston at top dead centre (TDC).
  5. Lubricate the balance shaft lobes with engine oil.
  6. Install the balance shafts (1) into their bores.

    7. Caution: Refer to Fastener Caution in the Preface section.

  7. Install the balance shaft retaining bolts and tighten to 10 N·m (89 lb in).
   


© Copyright Chevrolet. All rights reserved