To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Fuel Pressure Sensor Replacement - Fuel Feed Pipe

Removal Procedure

  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief .

  2. 1885087
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Disconnect the body wiring harness electrical connector (1) from the fuel pressure sensor (2).

  5. 1885089
  6. Wrap a shop towel around the fuel pressure sensor fitting in order to absorb any fuel that may leak out.
  7. Remove the fuel pressure sensor (1) from the fuel line.
  8. Remove and discard the fuel pressure sensor O-ring seal (2).

Installation Procedure


    1885089
  1. Lubricate a NEW fuel pressure sensor O-ring seal with clean engine oil.
  2. Install the NEW fuel pressure sensor O-ring seal (2) onto the fuel line fitting.
  3. Caution: Refer to Fastener Caution in the Preface section.

  4. Install the fuel pressure sensor (1) to the fuel line. Tighten the sensor to 15 N·m (11 lb ft).

  5. 1885087
  6. Connect the body wiring harness electrical connector (1) to the fuel pressure sensor (2).
  7. Lower the vehicle.
  8. Use the following procedure in order to inspect for leaks:
  9. 6.1. Turn the ignition ON, with the engine OFF, for 2 seconds.
    6.2. Turn the ignition OFF for 10 seconds.
    6.3. Turn the ignition ON, with the engine OFF.
    6.4. Inspect for fuel leaks.
   


© Copyright Chevrolet. All rights reserved