To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Clutch Actuator Cylinder Pipe Replacement

Removal Procedure

  1. Remove the transmission. Refer to Clutch Assembly Replacement : Diesel Engine → 2.4 Engine

  2. 2572127
  3. Remove the clutch actuator cylinder pipe connector elbow clip (1).
  4. Remove the clutch actuator cylinder pipe connector elbow (2) from the clutch concentric actuator cylinder pipe end.
  5. Note: Release the fastening sleeve key (arrows) using a screwdriver or equivalent to remove the fastening sleeve.

  6. Remove the fastening sleeve (3) carefully out of the transmission housing and clutch concentric actuator cylinder pipe

  7. 2373094
  8. Loosen the clutch actuator cylinder pipe nut (3) from the clutch actuator cylinder.
  9. Remove the clutch actuator cylinder pipe (2) from the transmission housing and clutch actuator cylinder.

Installation Procedure


    2373094
  1. Position the clutch actuator cylinder pipe (2) to the transmission housing and clutch actuator cylinder.
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the clutch actuator cylinder pipe nut (1) and tighten to 18 Nm (13 lb ft).

  4. 2572127
  5. Install the fastening sleeve (3) carefully to the transmission housing and clutch actuator cylinder pipe.
  6. Install the clutch actuator cylinder pipe connector elbow (2) to the clutch actuator cylinder pipe end.
  7. Install the clutch actuator cylinder pipe connector elbow clip (1).
  8. Install the transmission. Refer to Clutch Assembly Replacement : Diesel Engine  → 2.4 Engine .
   


© Copyright Chevrolet. All rights reserved