To the top of the document
Cruze
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Engine Coolant Fan Resistor Replacement - Gasoline

Removal Procedure
  1. Disconnect the negative cable from the battery. Refer to Battery Negative Cable Disconnection and Connection .

    2. 2028322
  2. Disconnect the engine coolant fan resistor wiring harness plug.
  3. Remove the engine coolant fan resistor bolt (2).
  4. Remove the engine coolant fan resistor (1).

Installation Procedure

    2028322
  1. Install the engine coolant fan resistor (1).

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the engine coolant fan resistor bolt (2) and tighten to 4 N·m (36 lb in).
  3. Connect the engine coolant fan resistor wiring harness plug.
  4. Connect the negative cable to the battery. Refer to Battery Negative Cable Disconnection and Connection .
   


© Copyright Chevrolet. All rights reserved